How to service your Fulcrum or Campagnolo freehub body

Mechanic Al Vines tells you all you need to know about replacing the bearings in your freehub

If you’re getting bored with your Christmas break already, now’s the time to try replacing the bearings in your freehub.

The cassette body is a part of the bike that takes a lot of stress as you ride, so it’s worthwhile to know how to service it and replace the bearings on which it runs, to keep your expensive wheels turning sweetly. With Campagnolo and Fulcrum wheels being made by the same company, they share many of their parts.

>>> 11 bike maintenance mistakes and how to avoid them

Servicing your freehub body is quite Upper Division and needs a few tools:

  • 17mm spanner
  • 5mm Allen key
  • Hammer and punch
  • Internal circlip pliers
  • Grease and a grease gun
  • Paper towels
  • A pack of Fulcrum or Campagnolo replacement bearings
  • A bearing press

The last of these will cost around £60. But it will set you up to sort out other bearings, like press fit bottom brackets and headsets too.

The Fulcrum bearings have the part number RS-011, while the equivalent Campagnolo part is FH-BUU004.

>>> Watch: how to fit lower gears on your bike (video)

Taking apart your freehub is also an opportunity to check the main wheel bearings for wear and potential replacement. Don’t use degreaser on anything until you’ve disassembled the freehub though, as you can potentially wash the grease out of the wheel bearings.

>>> Watch: how to use oil, grease and lubricants (video)

You need to punch out the two bearings in the freehub, which are to be replaced and clean everything. Then you can fit the replacement bearings using the bearing press to make sure that they are pushed in straight.

Don’t forget to grease everything as you go.

You can then refit the pawls and spring, then grease the ratchet ring and axle before refitting the freehub body and refitting the spacer and lockring.

Thank you for reading 20 articles this month* Join now for unlimited access

Enjoy your first month for just £1 / $1 / €1

*Read 5 free articles per month without a subscription

Join now for unlimited access

Try first month for just £1 / $1 / €1

Paul Norman

Paul started writing for Cycling Weekly in 2015, covering cycling tech, new bikes and product testing. Since then, he’s reviewed hundreds of bikes and thousands of other pieces of cycling equipment for the magazine and the Cycling Weekly website.

He’s been cycling for a lot longer than that though and his travels by bike have taken him all around Europe and to California. He’s been riding gravel since before gravel bikes existed too, riding a cyclocross bike through the Chilterns and along the South Downs.